MyWeigh Pointscale 5.0 - Manual (Page 4)

Always perform calibration procedure after first turning the unit on and allowing it to warm up and
stabilize for 20 seconds. If possible please calibrate the scale on your SCALEPAD (included in the box),
mousepad or similar surface. Calibrate your scale at regular intervals if the scale is subject to weather or
altitude changes or if the display shows Out2. Incorrect calibration can occur if you do not follow the
steps exactly. If your scale does not perform accurately, please also try replacing your batteries.
*Correct Calibration Weights:
Pointscale 150: 100g weight | Pointscale 500: 200g weight
Calibration Procedure:
1) Turn the scale OFF and Place the it on a Flat, very stable surface
(Be certain the scale is OFF)
2) Press and hold the “CAL” key for 5 seconds until a random large
number appears on the display - then release the key.
3) Press the CAL key again, the display will show 2Ero and then 100.0 or 200.0 (depending on model)
4) Gently place the correct calibration weight on the tray and wait 3 seconds.
5) Press the CAL key. The display will show CAL and then PASS,
calibration is complete. Gently remove the weight and turn the scale Off.
NOTE: if after calibration your scale does not read accurately, this indicates calibration error and the
calibration process should be repeated more slowly. Please calibrate on your scalepad, mousepad or
similar surface if possible.
POINTSCALE 4.0 CALIBRATION
This is ONLY for the Pointscale 4.0. The Pointscale 4.0 says "Pointscale 4.0" on the front of the scale.
Important: Always perform calibration procedure after first turning the unit on and allowing it to warm
up and stabilize for 20 seconds. If possible please calibrate the scale on your SCALEPAD (included in the
box), mousepad or similar surface. Calibrate your scale at regular intervals if the scale is subject to
weather or altitude changes or if the display shows Out2. Incorrect calibration can occur if you do not
follow the steps exactly. If your scale does not perform accurately, please try replacing your batteries
before you calibrate.
1. Turn the scale OFF and Place the it on a Flat, very stable surface. Be certain the scale is OFF.
2. Press and hold the "CAL" key for 5 seconds until a random large number appears on the display,
then release the key.
3. Press the CAL key again, the display will show 2Ero and then 100.0 or 200.0
4. Gently place the correct 100 gram or 200 gram weight (depending on what was just shown in
the previous step) on the scale and wait 3 seconds.