MSI Keeper 945GM V1.0 - Manual (Page 27)

M S-9641 M ainboard
2-14
Fan Power Connectors: CPUFAN0, SYSFAN1, AUXFAN0
The fan power connectors support system cooling fan with +12V. W hen connecting
the wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be connected
to GND. If the mainboard has a System Hardware Monitor chipset on-board, you must
use a specially designed fan with speed sensor to take advantage of the CPU fan
control.
SYSFAN1
+12V
GND
NC
CPUFAN0
Important
Please refer to the recommended CPU fans at Intel ® official website or
consult the vendors for proper CPU cooling fan.
NC
+12V
GND NC
+12V
GND
AUXFAN0
PIN SIGNAL DESCRIPTION
1 HD_LED + Hard disk LED pull-up
2 FP PWR/SLP MSG LED pull-up
3 HD_LED - Hard disk active LED
4 FP PWR/SLP MSG LED pull-up
5 RST_SW - Reset Switch low reference pull-down to GND
6 PWR_SW + Power Switch high reference pull-up
7 RST_SW + Reset Switch high reference pull-up
8 PWR_SW - Power Switch low reference pull-down to GND
9 RSVD_DNU Reserved. Do not use.
JFP1 Pin Definition
Front Panel Connectors: JFP1
The mainboard provides two front panel connectors for electrical connection to the
front panel switches and LEDs. The JFP1 is compliant with Intel
® Front Panel I/O
Connectivity Design Guide.
1
2
9
10
JFP1
HDD
LED Reset
Switch
Power
LED Power
Switch
+
+
+ - -
-