Alamo FALCON 15/10 - Manual (Page 95)

OPERATION
FACLON 15/10 03/09 Operation Section 4-5
© 2009 Alamo Group Inc.
OPERA
T
ION
3. TRACTOR REQUIREMENTS
In addition to tractor horsepower and size required to operate the mower unit, the tractor must also be properly
equipped to provide operator protection, to alert approaching vehicle drivers of the tractor’s presence, and to
ensure tractor stability when mowing with the boom fully extended.
Tractor Requirements and Capabilities
• ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
• Tractor Safety Devices ..................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
• Tractor Horsepower-Minimum .......... Falcon 10 40HP; Falcon 15 50HP
• -Maximum......................................... 540 RPM Unit-100 HP; 1000 RPM Unit 140 HP
• Hydraulics......................................... Wing Hydraulic Motors rated at 70 HP @ 2000 PSI
Center Hydraulic Motor rated at 75 HP @ 3000 PSI
• Power Take Off ................................. 540 RPM
• Tire Wheel Spacing .......................... Set tires minimum width of 60” from inside to inside of tires.
3.3 Tractor Horsepower
The horsepower required to operate the mower depends on many factors including vegetation to be cut, terrain
condition, operator experience, and condition of the mower and tractor. For most mowing condition, the Falcon
10 rotary mower require a tractor with at least 40 HP and 50 HP for Falcon 15. Operating the mower with a
tractor that does not have adequate power may damage the tractor engine.
3.1 ROPS and Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved roll-
over-protective system (ROPS). Always wear seat belts. Serious injury or
even death could result from falling off the tractor--particularly during a turnover
when the operator could be pinned under the ROPS.
(SG-7)
3.2 Tractor Safety Devices
If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with
proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of
the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor
warning signals are obscured.
Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were
removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO
with the PTO master shield missing or in the raised position. OPS-U- 0004