Alamo FALCON 15/10 - Manual (Page 87)

ASSEMBLY
FALCON 15/10 03/09 Assembly Section 3-5
© 2009 Alamo Group Inc.
ASSEMBL
Y
ATTACHING CYLINDER HOSES
Attach cylinder hoses to Tractor QD Remotes (Requires Three Spool Tractor Remote Valve to Operate Each
Wing and Axle Independently) or use Three Spool Control Valve Option. Proper QD couplers will need to be
attached to hydraulic hoses.
Operating Mower Hydraulics with Three Tractor Hydraulic Ports
Connect one hose into each hydraulic port. Connect lines to correspond with position of hydraulic control
levers.
Operating Mower Hydraulics with Two Tractor Hydraulic Ports
The lines that operate the wings must be plumbed together and will be controlled using one hydraulic control
valve and the center section with the remaining control valve. Ensure that the operator is aware that each wing
cannot be controlled independently nor will they raise and lower simultaneously.
ATTACHING ELECTRICAL CONNECTIONS
Attach the free ends of the mower wire harness to a switched power supply of the tractor (Requires 25 Amp
Minimum Service). Alamo industrial suggest using the Tractor Auxiliary Power Connector inside the tractor. (If
tractor is equipped) The Connector is available from the tractor dealer. If desired, a switch, rated at 25 amp
min, can be installed in the power supply line to selectively turn the unit off and on.
LEVELING UNIT
The mower Must Be Leveled after attaching to the tractor. To level the implement correctly refer to Section 7
SETTING THE MOWER of the Operators Section of this manual.