Alamo FALCON 15/10 - Manual (Page 139)

MAINTENANCE
FALCON 15/10 03/09 Maintenance Section 5-3
© 2009 Alamo Group Inc.
MAINTENANCE
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
Lubrication
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
accompanying illustration shows lubrication points. The chart gives the frequency of lubrication in hours, based
on normal operating conditions. Severe or unusual conditions may require more frequent lubrication. FIGURE
MntP-R-0072.
Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly
before using grease gun.
Lubrication Fitting Location
ITEM DESCRIPTION FREQUENCY
1 Spindle Weekly
2. Axle Turnbuckle 8 Hours
3. Tongue Pivot 8 Hours
4. Wheel Hubs Weekly