KMW Communications AMS Lite - Manual (Page 21)

Sheet 21 of 30 Sheet 21 of 30 8/17/2008
©
CONFIDENTIAL
Table- Set Device Data List
ITEM Description Remark
IP Address TICU IP Address
Gateway TICU Gateway
Subnetmask TICU Subnetmask
Port TICU TCP Port
Server IP Server IP ( PC Application)
Server Port Server Port
BTS ID/Name BTS name 20Bytes
Setup Date TICU setup date
) TICU Reset
When “TICU Reset” (Figure 7-1) button is clicked, the TICU will be rebooted. It takes about 5 seconds.
In case of soft reset, the ALD information will be remained. But if you turn on the power after turn off,
the ALD information will be cleared.
) Refresh
When “Refresh” (Figure 7-1) button is clicked, the information in Figure 7-1 will be updated.
) Device Scan
The function “Device scan” searches all ALDs ID and serial number connected to the TICU. This
function will be used in the case of the system setup, system reinstall. If you don ’t know which ALD is
attached to the TICU, this will be also used.
It takes about 3 minutes. When the Device scan is completed, the ALD lists will be displayed to the
connected list. During device scan, Can ’t send the ALD command.
) ALD Reset
When “ALD Reset” (Figure 7-1) button is clicked, all ALDs attached to the TICU will reset.