iRobot Looj 330 - Manual (Page 19)

www.irobot.com 19
5. Press the power button on the robot to turn it on. The power
light should be green to indicate that its battery is charged.
A slow blinking red light indicates that you should charge
Looj’s battery. (For all LED indicators please see the
indicator lights section on Page 22.)
6. Detach the remote control handle.
7. Select your auger direction. If you press the left arrow
of the auger spin direction button (A), debris will be
thrown to the left. If you press the right arrow, it will be
thrown to the right (B).
8. Ensure that the auger is spinning and tossing debris
out of the gutter and away from the building.
9. Press the “CLEAN” button if you would like the robot to clean your
gutter on its own in auto-mode. Press any button to cancel out of auto
modes at any time. At the end of the “CLEAN” cycle, you will have to
drive the robot back to you manually.
11. The LED on the remote control handle will display different
messages depending on what the robot is doing. For a list of all
LED indicators, please see the indicator lights section on page
22.
12. Once Looj reaches the end of the gutter, drive it back to you.
Keep the auger spinning to help drive under the gutter straps.
13. Turn off the power switch off on the robot. The remote will
power off on its own after a time delay.
14. Attach the remote control handle to remove Looj from the gutter
and clip Looj to the belt clip before descending.
15. Descend the ladder following safety instructions from ladder
manufacturer. See Page 4 for more ladder safety warnings.
TIP: Should the robot ever turn sideways or flip over in your gutter,
spin the auger in the opposite direction and back the robot up to
right itself.
TIP: Never start Looj while the auger is in front of you on the
ladder. Always clear the debris near the ladder by hand, and drive
the robot with auger pointed away from you to avoid debris spray.
Robot buttons and controls Robot Action
Handle Release Button Detaches the handle from the robot
Auger Spin (Direction Left) Spins the auger to the left
Auger Spin (Direction Right) Spins the auger to the right
Auger Neutral Position (Button in
Center Position)
Auger will not spin (Do not use while driving in gutter)
Press and Hold Forward Button Moves the robot forward
Press and Hold Reverse Button Moves the robot backward
Click once and Hold Forward
Button
Moves the robot forward at half speed
Double Click Reverse Button Automatically backs the robot up. No need to hold the
backward button.
Press “Clean” Button Puts the robot in auto mode to clean your gutters on its own
Robot Controls