iRobot Looj 330 - Manual (Page 18)

18 iRobot Looj 300 Series Owner’s Manual
5. Press the power button on the robot to turn it on. The power
light should be green to indicate that its battery is charged.
A slow blinking red light indicates that you should charge
Looj’s battery. (For all LED indicators please see the
indicator lights section on Page 22.)
6. Detach the remote control handle.
7. Select your auger direction. If you press the left arrow
of the auger spin direction button (A), debris will be
thrown to the left. If you press the right arrow, it will be
thrown to the right (B).
8. Ensure that the auger is spinning and tossing debris
out of the gutter and away from the building.
9. Press the “CLEAN” button if you would like the robot to clean your
gutter on its own in auto-mode. Press any button to cancel out of auto
modes at any time. At the end of the “CLEAN” cycle, you will have to
drive the robot back to you manually.
CAuTION: Wear safety glasses when using Looj to protect your eyes
from debris.
CAuTION: do not stand underneath the gutter while Looj is operating.
TIP: Note that one direction will spin the debris away from
the building and the other direction will spin the debris
onto the roof. Test the spin direction before driving the
robot down the gutter.
B
A
CAuTION: Always watch the robot when cleaning in auto mode.
If the robot starts to climb out of the gutter for any reason, push
any button to cancel and then drive the robot backwards.
10. To drive the robot in manual mode press the forward and
backward buttons to drive the robot through the gutter and
remove debris. Press the forward button once and then hold to
go at half speed for tough clogs. Double click the back button to
go into auto-reverse mode.