iRobot Mint 5200 - Manual (Page 31)

PAGE 31
Trouble Shooting
Solution
If the red light turns off after the 3 beeps, but occurs again when you press the
Sweep or Mop button, Mint Plus is not ready to clean due to an activated sensor.
Check to make sure:
Both ends of the cleaning cloth are securely tucked into the blue gripping strips
or onto the Pro-Clean velcro strips and the cloth is not bunching up.
The cleaning cloth is not in the middle channel of the removable
cleaning pad.
The removable, magnetic cleaning pad is firmly reattached to Mint Plus.
Press Mint Plus’s power button for 5-6 seconds to power it off.
Manually rotate both of Mint Plus’s wheels and set Mint Plus on the floor.
Power Mint Plus back on.
If the red light is gone, press the Sweep button to confirm Mint Plus can now
drive forward.
If the red light persists or recurs, contact customer support.
Mint Plus has encountered a problem in its environment and needs help.
Problems could include getting physically stuck or being unable to find its
way out of a confined area.
Mint Plus will also periodically play a two-tone distress sound to alert you
it needs help.
Remove Mint Plus from its situation.
Mint Plus will go into Pause mode when moved.
Place Mint Plus back on the floor near the Cube where it started.
Press the blinking cleaning mode button to resume cleaning.