iRobot Mint 5200 - Manual (Page 19)

PAGE 19
Using the Pro-Clean Reservoir Pad
The Pro-Clean Reservoir Pad dispenses liquid as Mint Plus mops to
keep the cleaning cloth wet longer.
Empty any remaining fluid from the reservoir.
Leave the fill cap open to allow reservoir to dry completely. Do not store the pad on
Mint Plus if wet.
See page 23 for care instructions.
Notice:
To avoid the Pro-Clean Reservoir Pad leaving excess
fluid on your floor, do not leave Mint Plus unattended when
mopping and remove from floor once Mint Plus stops cleaning.
Tip:
Fluid dispenses at different rates depending on floor type and solution
used. The first time you mop, start with the cloth only slightly damp and then
increase the starting cloth wetness if needed.
Fill the reservoir
Open the fill cap by pulling and swiveling
it to the side.
Fill reservoir with water and replace fill
cap, pressing it in securely so it does not
leak. Visit www.mintcleaner.com for infor-
mation about other cleaning solutions.
Fill the reservoir over a sink as a small
amount of fluid can leak out when the fill
cap is closed.
Dampen the blue Pro-Clean microfiber
cloth and press onto the velcro strips.
When mopping is finished: