iRobot Scooba 200 Series - Manual (Page 11)

www.irobot.com 11
Instructions for use
Before using your Scooba for the first time, you must:
Your charger will flash twice when plugged in to show that it has power.
Your Scooba battery is fully charged when the light on the charger is solid green.
using Your Scooba
These steps will guide you through setting up and cleaning the floor with your Scooba
emptying and Cleaning Your Scooba
1 Slowly add warm
water into FIll port.
Open both FIll and
eMPTY ports so
bladder can fully
expand. (Do not use
hot water.) 2 add Scooba Hard
Floor Cleaner.
(1 packet or ½ capful) 3 Firmly close
FIll and
eMPTY
ports until
sealed
4 Place Scooba in the
middle of the dirtiest
area on the floor. 5 Press power button
to turn on Scooba. 6 Press and release clean
button to begin the full
cleaning cycle.
For short cycle, press
and hold until second
song starts.
Insert the included
battery into Scooba
Plug in and charge
Scooba overnight
for the first charge.
1 empty and thoroughly rinse both tanks
with water.
2 Remove bottom plate.
Rinse and remove all debris
from brushes and squeegee. 3 Clear any debris on robot before replacing
bottom plate. If necessary, remove and
replace tires.
Place Scooba on storage mat to protect
bottom plate brushes. ensure charger jack
door is closed when using Scooba.