Cirrus Logic CS4384 - Manual (Page 35)

DS620F1 35
CS4384
6. REGISTER DESCRIPTION
Note: All registers are read/write in I²C Mode and write only in SPI, unless otherwise noted.
6.1 Chip Revision (Address 01h)
6.1.1 Part Number ID (PART) [Read Only]
00000- CS4384
6.1.2 Revision ID (REV) [Read Only]
000 - Revision A0
001 - Revision B0
Function:
This read-only register can be used to identify the model and revision number of the device.
6.2 Mode Control 1 (Address 02h)
6.2.1 Control Port Enable (CPEN)
Default = 0
0 - Disabled
1 - Enabled
Function:
This bit defaults to 0, allowing the device to power-up in Stand-Alone Mode. The Control Port Mode can
be accessed by setting this bit to 1. This will allow the operation of the device to be controlled by the reg-
isters and the pin definitions will conform to Control Port Mode. To accomplish a clean power-up, the user
should write this bit within 10 ms following the release of Reset.
6.2.2 Freeze Controls (FREEZE)
Default = 0
0 - Disabled
1 - Enabled
Function:
This function allows modifications to be made to the registers without the changes taking effect until the
FREEZE is disabled. To make multiple changes in the Control port registers take effect simultaneously,
enable the FREEZE Bit, make all register changes, then Disable the FREEZE bit.
7 6 5 4 3 2 1 0
PART4 PART3 PART2 PART1 PART0 REV2 REV1 REV0
0 0 0 0 0 - - -
7 6 5 4 3 2 1 0
CPEN FREEZE DSD/PCM DAC4_DIS DAC3_DIS DAC2_DIS DAC1_DIS PDN
0 0 0 0 0 0 0 1