Quick start instructions, Need more pumping features, Setup pumping parameters – Next Advance SP300 User Manual
Page 2: Load the syringe, Purge, Start the pump, When pumping, Pump reset
NEXT>>>ADVANCE
www.nextadvance.com
SP300 Programmable Syringe Pump
i
03/23/10
Quick Start Instructions
Plug in the pump.
Press the power switch to turn on power.
Press any key to stop the display from blinking.
Setup Pumping Parameters
To Change Numbers:
Use the arrow keys to increment individual digits.
To move the decimal point
: Press and hold the left-most arrow key for at least 1 second. When the digit
increments from 9 to 0, the decimal point will begin to shift. Release the key when the decimal point is correct.
Press any non-arrow key, or wait 2 seconds, to enter the new setting. The display will blink when a new value
is entered and stored in memory.
Set the Syringe Inside Diameter:
Momentarily press the ‘Diameter’ key. Set the inside diameter of the syringe in millimeters (mm).
Set the Pumping Rate.
Momentarily press the ‘Rate’ key.
To change the
pumping rate units
:
Momentarily press the ‘Rate’ key again. The display will show:
Press any arrow key to select the next available rate units.
Press any non-arrow key, or wait 2 seconds, to set the rate units.
Set the pumping rate. If the pumping rate is out of range, the display will show:
Load the Syringe
Press in the white drive-nut button to move the pusher block.
Lift and turn the syringe clamp away from the syringe holder block
Position the syringe on the pump with the flange to the left of the syringe holder block.
Lift and turn the syringe clamp onto the syringe body.
Move the pusher block next to the syringe plunger.
Purge:
Press and hold the ‘Start/Stop’ key for one second. Release to stop.
Press and hold the direction button to reverse the pump and release the pusher block
if jammed.
Start the Pump:
Press and release the ‘Start/Stop’ key to start or stop the pump.
When Pumping
The pumping rate can be changed.
PUMP RESET:
Press and hold the right-most up arrow key while turning on power to the pump.
Need more pumping features?
Visit
www.nextadvance.com
to see our full-featured syringe pumps.