DuraVent FasNSeal Single-Wall - Manual (Page 15)

15
Figure 16
TOP PLATE
SEALANT
ExISTING
MASONRy
CHIMNEy
Figure 15
INSTRUCTIONS
1. If a tee is needed lower down the liner as in
Step 3 of the previous section to the proper
location, even with the opening in
the chimney.
2. Attach the appropriate drain fitting to the
bottom of the Tee Body.
3. Be sure to remember to connect the
condensate drain at the bottom of the stack.
See previous section on Condensate Drains
for instructions.
FASNSEAL FLEx TERMINATIONS
For the standard vertical termination
installations see previous section vertical,
through the roof installation or follow
steps below.
1. Slide the Top Plate over the Flex Liner and
seal the Top Plate to the masonry chimney
using a bead of non-hardening sealant
around the top of the chimney and underside
of the Top Plate (Figure 15).
2. Leave at least 4 additional inches of
FasNSeal Flex to allow the Rain Cap to
sufficiently grab the liner.
3. Slip the Storm Collar portion of the Rain
Cap over the liner, position it over the Top
Plate and tighten draw band. Reassemble
Rain Cap (Figure 16).
RAIN CAP
STORM
COLLAR
TOP
PLATE