Kramer Electronics FC-340 - Manual (Page 16)

FC-340 - Operating the FC-340
13
13
7 Operating the FC-340
In general operation, the video signal received on the SDI IN connector is output
simultaneously on both SDI OUT connectors as well as the composite video
ANALOG OUTPUT connector. The audio embedded in the SDI input signal is
output on both AES/3id connectors simultaneously as well as on the balanced
audio ANALOG OUTPUT.
When the FC-340 is powered on, the following is displayed briefly:
FC340
KRAMER
The device then performs a self test. If the test is successful the Menu is displayed
as shown below.
VIDEO OUT >
AUDIO OUT >
If there is no button activity for approximately 30 seconds, the display reverts to
displaying the input status and output resolution similar to that shown below:
IN unlocked
OUT 1080p59.94
7.1 Changing the Output Resolution
To change the output resolution:
1. Press the Enter button to display the menu.
The menu is displayed.
2. Using the up (▲) or down (▼) button, move through the menu options until
the flashing cursor is on Video Out.