Kramer Electronics VS-88HC - Manual (Page 25)

Operating the VS-88HC
21
8 Operating the VS-88HC
You can operate your VS-88HC via:
The front panel buttons
RS-232/RS-485 serial commands transmitted by a touch screen system,
PC, or other serial controller
Infra-red remote control transmitter
This section describes:
The 7-segment display
How to use the front panel buttons
How to set and adjust the audio delay time
8.1 Displaying Unit Characteristics
Table 7 defines the information shown on the VS-88HC 7-segment display:
Table 7: 7-segment Display Information
Displayed Information When:
The video and audio inputs switched
to the outputs (for example, input 2 is
switched to output 1 and output 3)
During normal operation:
The machine name immediately
followed by the firmware version
number (1.0 01)
Immediately after switching on the power; and when
simultaneously pressing the three INPUT buttons 1, 2 and 3, for 3
seconds:
The audio and video setup to be
recalled after momentarily showing
the setup # (blinking)
When recalling a setup:
The digital audio sampling rate in kHz
(for example, 96) and the delay time 1
in milliseconds (for example, 296)
When setting the audio delay time:
1 To set the delay time, see section 8.6