Kramer Electronics VS-88HC - Manual (Page 23)

Controlling the VS-88HC
19
7.3 Controlling the VS-88HC via the ETHERNET Port
You can connect the VS-88HC via the Ethernet, using a crossover cable (see
section 7.3.1) for direct connection to the PC or a straight through cable (see
section 7.3.2) for connection via a network hub or network router.
7.3.1 Connecting the ETHERNET Port directly to a PC (Crossover
Cable)
You can connect the Ethernet port of the VS-88HC to the Ethernet port on
your PC, via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the factory default
IP Address of the VS-88HC during the initial configuration
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select
Properties.
3. Right-click Local Area Connection Properties.
4. Select
Properties.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the Properties Button (see
Figure 9).
Figure 9: Local Area Connection Properties Window