Kramer Electronics VS-81H - Manual (Page 12)

VS-81H - Connecting the VS-81H 9
5 Connecting the VS-81H
To connect the VS-81H 8x1 HDMI Switcher (as illustrated in Figure 3 ), do the
following:
1. If required:
ƒ Set the appropriate INPUTS to the DVD mode (see Section 6.1 )
ƒ Acquire the EDID (see Section 6.2 )
2. Connect the HDMI sources as follows:
You do not have to connect all the HDMI sources.
Alternatively, you can connect a PC to any of the inputs and set those inputs to the PC
mode (see
Section 6.1)
ƒ A multimedia player to INPUT 1
ƒ A set top box to INPUT 2
ƒ A DVD player to INPUT 6
ƒ A DVD player to INPUT 8
3. Connect the OUTPUT HDMI connector to an HDMI acceptor (for example, a
plasma display).
4. If required, connect a PC and/or controller to the RS-232 port (see
Section 6.3 ) and/or the ETHERNET port (see Section 6.4 ).
5. Connect the power connector to the mains electricity (not shown in Figure 3 ).
Press an INPUT SELECTOR button (from 1 to 8) to choose the HDMI input to
route to the output.
Always switch off the power to each device before connecting it to your
VS-81H. After connecting your VS-81H, connect its power and then
switch on the power to each device.
i