beautypg.com

5 operating the vs-801usb, 1 the front panel buttons, 2 the remote terminal block connector – Kramer Electronics VS-801USB User Manual

Page 13: 3 the application software, Operating the vs-801usb, The front panel buttons, The remote terminal block connector, The application software, N 5.2, 5operating the vs-801usb

background image

10

VS-801USB - Operating the VS-801USB

5

Operating the VS-801USB

You can operate the

VS-801USB via the front panel buttons (see

Section 5.1

), the

REMOTE contact closure terminal block connectors (see

Section 5.2

), the

application software (see

Section 5.3

) or the

RC-IR3 IR remote control transmitter.

5.1

The Front Panel Buttons

To select a DEVICE to switch to the HOST, press one of the eight DEVICE
SELECT buttons.

5.2

The REMOTE Terminal Block Connector

The contact closure remote control pins operate in a similar way to the INPUT
SELECT button. Using the contact closure remote control (also known as push-to-
make momentary contact) you can select the desired USB port. To do so,
momentarily connect the required DEVICE pin (from 1 to 8) on the REMOTE
terminal block connector to the G (Ground) pin, as

Figure 5

illustrates.

!

Do not connect more than one PIN to the GND PIN at the same time.

Figure 5: Connecting the Contact Closure Remote Control PINs

5.3

The Application Software

Use the K-SINGLE control application software to control the

VS-801USB via the

Ethernet or RS-232 9-pin D-sub.

i

The latest version of K-SINGLE and installation instructions can be
downloaded from the Kramer Web site at

www.kramerelectronics.com