Kramer Electronics VS-41HDCP User Manual

Page 32

VS-41HDCP - Kramer Protocol

Command
Name

Short Cmd

Command Type

Permission

NET-DHCP

NTDH

Ethernet

Administrator

Set DHCP mode

Syntax

#NET-DHCP

␠

mode

␍

Response

nn@

NET-DHCP

␠

mode

␠

␍␊

Parameters

mode -

‘0’ – Don't use DHCP (Use IP set by factory or IP set command).

‘1’ – Try to use DHCP. If unavailable, use IP as above.

Notes

Connection of Ethernet to devices with DHCP may take more time in some networks.
To allow connecting if randomly assigned IP by DHCP - Give the device DNS name (if
available) by the command “NAME”. It possible to get assigned IP also by direct connection
to USB or RS-232 protocol port if available.
For proper settings consult your network administrator

Command Name

Short Cmd

Command Type

Permission

NET-DHCP?

NTDH?

Ethernet

End User

Get DHCP mode

Syntax

#NET-DHCP?

␍

Response

nn@

NET-DHCP

␠

mode

␍␊

Parameters

mode -

‘0’ – Don't use DHCP (Use IP set by factory or IP set command).

‘1’ – Try to use DHCP. If unavailable, use IP as above.

Notes

Command Name

Short Cmd

Command Type

Permission

NET-GATE

NTGT

Ethernet

Administrator

Set Gateway IP

Syntax

#NET-GATE

␠

ip_address

␍

Response

nn@

NET-GATE

␠

ip_address

␠

␍␊

Parameters

ip_address

– format: xxx.xxx.xxx.xxx

Notes

Network gateway allows connecting to the device via another network and maybe over
Internet. Be careful of security problems.
For proper settings consult your network administrator