Excluding unwanted channels, Selecting a tv channel – AVerMedia Technologies 1500 MCE User Manual

Page 16

Chapter 3

-12-

8. Click

Yes to start all frequency auto-scan. The application will then scan

frequencies starting from 54 MHz to over 800 MHz, increasing by 1 MHz at a
time. The application will check these frequencies for active channels,
memorizing those that are.

Wait for the application to finish the all channel scan process or in the All
Frequency Scan dialog box, click

Stop to terminate the searching process.

9. If you change your mind and want to revert to the default frequency table, click

All Frequency Scan again and choose Restore.

Excluding Unwanted Channels

If you want to exclude undesirable channels from your channel list, do the following:

1. Click the

Setup

button

and click the

Channel

tab.

2. In the S

etup

dialog box, Channel column, click the

unwanted channel. The check mark will be
removed, indicating that the channel will be
excluded from your channel list and that you
won’t be able to access and watch them through
the

Channel Up/Down button.

Selecting a TV Channel

There are three ways of switching between TV channels:

Click the

Channel Up/Down buttons repeatedly until you

reach your desired channel.

Click

to open the Numeric Panel (as shown to the right).

Then click on the

Numeric buttons to get your desired

channel number.

OR,