Kramer Electronics VP-443 - Manual (Page 18)

14 VP-443 - Controlling the VP-443
Mode Function
FACTORY
RESET Resets to the default parameters
If you cannot see the display after factory reset, use the front panel Res. button to
set the correct resolution: press continuously for 2 seconds to reset to XGA, or
continuously for 5 seconds to reset to 720p
INFORMATION Displays the source, the input resolution, the output resolution and the software
version
AUTOSYNC
OFF Turn the auto sync ON/OFF. When ON, this de-activates the output after a few
minutes if no input is present.
This is useful, for example, when the output is connected to a projector, and the
projector will automatically shut down when it has no input
EXIT Select to exit the menu
6.2.2 The FINETUNE Menu
Input Signal Parameter Function
CV,
COMPONENT HUE Set the color hue
SATURATION Set the color saturation
SHARPNESS Set the sharpness of the picture
NOISE
REDUCTION Select the noise reduction: OFF, HI, LOW and MID (middle)
COLOR
FILTER Set to ON to enable color filtering
May improve the output image for certain graphic cards where
color fringing is seen
VGA PHASE Set the clock phase
CLOCK Set the clock frequency
H-POSITION Set the horizontal position of the picture
V-POSITION Set the vertical position of the picture
AUTO TUNE When set to ON, auto adjusts the image (centers it correctly
on the screen) every time the input is switched to VGA or
when the input resolution changes
Alternatively, you can auto adjust the image by pressing the
ENTER button when not within the OSD menu
COLOR
FILTER Set to ON to enable color filtering
May improve the output image for certain graphic cards where
color fringing is seen
HDMI COLOR
FILTER Set to ON to enable color filtering
May improve the output image for certain graphic cards where
color fringing is seen
DROP LINES Set it to ON to eliminate the green line (default is OFF)
With some sources (mostly Apple devices) a green line
sometimes appears at the bottom of the display. By factory
default this option is set to OFF.
6.2.3 The AUDIO Menu
Parameter Function
OUTPUT VOLUME Set the output volume (from 0 to 100)
Not applicable for embedded HDMI inputs
INPUT VOLUME Set the input volume (from 0 to 100)
Not applicable for embedded HDMI inputs