Kramer Electronics VP-443 - Manual (Page 13)

VP-443 - Connecting the VP-443 9
9
5 Connecting the VP-443
Always switch off the power to each device before connecting it to
your VP-443. After connecting your VP-443, connect its power and
then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
To connect the VP-443, as illustrated in the example in Figure 3 , do the following:
1. Connect an HDMI source (for example, a DVD player) to the HDMI VIDEO
INPUT connector (from 1 to 4).
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-443 via a DVI-HDMI adapter. When using this adapter, you can
connect the audio signal via the terminal block connector
2. Connect a computer graphics source to the PC 1 15-pin HD VIDEO INPUT
connector.
3. Connect a composite video source (for example, a composite video player)
to the CV VIDEO INPUT RCA connector (from 1 to 2).
4. Connect a component video source (for example, a component video player)
to the COMP 1 P R , P B and Y, VIDEO INPUT RCA connectors.
5. Connect the audio input signals to the AUDIO IN terminal block connectors,
as required (not shown in Figure 3 ).
6. Connect the RGBHV VIDEO OUTPUT BNC connectors to an RGBHV
acceptor (for example, an RGBHV display).
7. Connect the HDMI VIDEO OUTPUT connector to an HDMI acceptor (for
example, a plasma display).
8. Connect the VGA VIDEO OUTPUT 15-pin HD connector to a VGA acceptor
(for example, a projector).
!
i