Kramer Electronics VP-2x2 User Manual

Page 7

Connecting the VP-2x2 2x2 XGA/Audio Matrix Switcher

5 Connecting the VP-2x2 2x2 XGA/Audio Matrix Switcher

This section describes how to connect:

The

VP-2x2 rear panel (see section 5.1)

A balanced stereo audio input/output (see section 5.2)

The

VP-2x2 to a controlling device via RS-232 (see section 5.2)

5.1 Connecting the VP-2x2 2x2 XGA/Audio Matrix Switcher Rear Panel

To connect

the

VP-2x2, as illustrated in the example in Figure 2, do the

following

1. Connect the VGA/UXGA computer graphics sources to the INPUT 15-

pin HD computer graphics video connectors.

2. Connect the balanced

stereo audio sources to the AUDIO IN balanced

stereo audio 5-pin terminal block connectors.

3. Connect the OUTPUT 15-pin HD computer graphics video connectors to

the VGA/UXGA video acceptors (for example, displays).

4. Connect the AUDIO OUT terminal block connectors to the balanced

stereo audio acceptors (for example, amplifiers with speakers).

5. Connect a PC and/or controller (if required) to the RS-232 port (see

section 5.2).

6. Connect the 12V DC power adapter to the power socket and connect the

adapter to the mains electricity (not shown in Figure 2).

1 You do not have to connect both inputs or both outputs
2 Switch OFF the power on each device before connecting it to your VP-2x2. After connecting your VP-2x2, switch on its
power and then switch on the power on each device
3 See section 5.2