Kramer Electronics VP-12x8 User Manual

Page 18

Operating the VP-12x8

In the Confirm mode (TAKE button is illuminated):

You can key-in several actions and then confirm them by pressing the

TAKE button, to simultaneously activate the multiple switches

Every action requires user confirmation, protecting against erroneous

switching

Execution is delayed

until the user confirms the action

7.2.1

Toggling between the At Once and Confirm Modes

To toggle between the At Once and Confirm modes, do the following:

1. Press the TAKE button to toggle from the At Once mode (in which the

TAKE button is not illuminated) to the Confirm mode (in which the

TAKE button illuminates).

Actions now require user confirmation and the TAKE button illuminates.

2. Press the illuminated TAKE button to toggle from the Confirm mode

back to the At Once mode.

Actions no longer require user confirmation and the TAKE button no

longer illuminates.

7.2.2

Confirming a Switching Action

To confirm a switching action (in the Confirm mode), do the following:

1. Press an OUT-IN combination.

The corresponding 7-segment display blinks. The TAKE button also

blinks.

2. Press the blinking TAKE button to confirm the action.

The corresponding 7-segment display no longer blinks. The TAKE button

illuminates.

To confirm several actions (in the Confirm mode), do the following:

1. Press each OUT-IN combination in sequence.

The corresponding 7-segment display blinks. The TAKE button also

blinks.

2. Press the blinking TAKE button to confirm all the actions.

The corresponding 7-segment display no longer blinks. The TAKE button

illuminates.

1 Failure to press the TAKE button within one minute (the Timeout) will abort the action