Kramer Electronics SID-X2N - Manual (Page 19)

SID-X2N - Configuring and Maintaining the SID-X2N 15
15
8 Configuring and Maintaining the SID-X2N
8.1 Setting the Configuration DIP-switch
The 8-way dip-switch provides the ability to configure a number of device
functions. A switch that is down is on, a switch that is up is off. By default, all
switches are up (off).
Figure 8: The Configuration DIP-switch
# Feature Function DIP-switch
1 Program Enables firmware updates On —Enable updating
Off —Disable updating
2 General audio
control Selects whether the analog
audio is embedded in the
outputs, (see
Section 6.2 )
On —Use embedded audio and
DIP-switch 3 controls DVI audio
Off
—Use analog audio
3 DVI audio control
(active only when
DIP-switch 2 is
on) Selects whether the analog
audio is embedded in the DVI
signal On —Use analog audio in DVI
signal
Off
—Use whatever audio is
present on the DVI input
4 Video mode input
selection Sets the video input selection
mode to either last connected or
manual On —Last connected
Off —Manual
5 Lock EDID Locks the current EDID, (see
Section 7.2 )
On —Locked EDID
Off —Automatic EDID selection
6 Switching delay Selects the time delay before
switching occurs when a input
cable is removed On —0.5seconds
Off —5 seconds
Note: When the input sync is lost
but the cable is not removed, the
delay is always six seconds
7
For future use
8
Note: DIP-switch 2 must be set to ON to enable DIP-switch 3 to control the DVI
audio mode selection.