Figure 2: sid-x1n step-in commander rear panel – Kramer Electronics SID-X1N User Manual
Page 10
6
SID-X1N - Defining the SID-X1N Step-in Commander
defines the rear panel of the SID-X1N.
Figure 2: SID-X1N Step-in Commander Rear Panel
#
Feature
Function
1
AUDIO OUT 3.5mm Mini Jack
Connect to an unbalanced, stereo audio acceptor, (see
Section
2
TP OUT RJ-45 Connector
Connect to a compatible switcher or DGKat receiver, (for
example, VP-81SIDN or PT-572+) using CAT 6 or higher
specification cable
3
REMOTE STEP-IN
3-pin Terminal
Block
LED
Connect to the anode of the remote Step-In LED indicator
4
Switch
Connect to the remote, Step-In switch, (see
Section
5
PROG RS-232 3-pin Terminal
Block
Connect to the PC via RS-232 to perform a firmware upgrade
6
REMOTE
SELECT 8-pin
Terminal Block
LED
Connect to the anode of the remote Input Select LED indicator,
(see
Section
7
Switch
Connect to the remote, Input Select switch, (see
Section
8
LED HDMI,
DP, DVI
and UXGA
Connect to the anodes of the remote input indicators
(see
Section
9
OPTION 8-way DIP-switch
Used to set the device behavior, (see
Section
10
12V DC Power Connector
Connect to supplied power adapter, center pin positive