Kramer Electronics 6502 - Manual (Page 8)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Technical Specifications
6
5.1 Controlling via RS-232 (for example, using a PC)
To connect a PC to the 6502 unit, using the Null-modem adapter provided
with the machine (recommended):
Connect the RS-232 9-pin D-sub rear panel port on the 6502 unit to the
Null-modem adapter and connect the Null-modem adapter with a 9-wire
flat cable to the RS-232 9-pin D-sub port on your PC
To connect a PC to the 6502 unit, without using a Null-modem adapter:
Connect the RS-232 9-pin D-sub port on your PC to the RS-232 9-pin
D-sub rear panel port on the 6502 unit, as Figure 3 illustrates
9-pin D-sub
(From PC)
9-pin D-sub
(Male)
If a shielded cable is used, connect the shield to PIN 5
PIN 4 is connected to PIN 6
PINs 8, 7, 1 are connected together
PIN 5 Connected to PIN 5 (Ground)
PIN 3 Connected to PIN 2
PIN 2 Connected to PIN 3
Figure 3: Connecting a PC without using a Null-modem Adapter
6 Technical Specifications
Table 2: Technical Specifications of the 6502 4x1 S/PDIF Switcher / DA
INPUTS: 4 digital audio S/PDIF on RCA connectors
OUTPUTS: 2 digital audio S/PDIF on RCA connectors
SAMPLING RATE: 32kHz to 192kHz
STANDARDS: CP1201, IEC 60958, AES3ID and S/PDIF
DIMENSIONS: 12cm x 6.95cm x 2.44cm (4.72" x 2.74" x 0.96", W, D, H)
POWER SOURCE: 5V DC, 140mA
WEIGHT: .3kg (0.66lbs.) approx.
ACCESSORIES: Power supply (5V/2A), mounting bracket, IR remote control transmitter
OPTIONS: 19" rack adapters
7 Table of Hex Codes for Serial Communication
Table 3 lists the Hex values for a single machine (MACHINE # 1):
Table 3: 6502 Hex Codes for Switching via RS-232
OUT 1
IN 1 , , ,
IN 2 , , ,
IN 3 , , ,
IN 4 , , ,