SawStop Sliding Crosscut Table - Manual (Page 17)

SawStop TSA-SA48 Sliding Crosscut Table | 13
Operations
1. To adjust the crosscut miter angle, loosen the crosscut fence lock knob to allow the crosscut fence to pivot.
Using the miter gauge angle indicator, set the fence to the desired miter angle and retighten the lock knob to
secure the fence in place.
Note: If using the rulers on the fence or fence extension to position the flip
stops, you should reposition the rulers after changing the miter angle.
2. To make repetitive cuts, loosen the appropriate flip stop lock knob and slide the flip stop into the desired
position. Retighten the lock knob to lock the flip stop in place.
3. Unlock the sliding table by pulling out the sliding table lock knob on the underside of the sliding table and
rotating it 90 degrees. This will enable the sliding table to move along its path without interference from the
pin.
4. To prevent the sliding table from moving, pull out the sliding table saw lock knob and rotate it 90 degrees.
Next, slowly slide the table toward the Home Position until the lock pin engages and the table locks in place.
When the sliding table is not in use, lock it in place so that it will not move unexpectedly.
5. For longer work pieces (up to 60"), make sure the fence is positioned over the extension table. Next, loosen
the crosscut fence extension lock knobs (233) and slide the fence to the left as needed to accommodate the
longer work piece. Retighten the fence extension lock knobs.