SawStop Sliding Crosscut Table - Manual (Page 16)

SawStop TSA-SA48 Sliding Crosscut Table | 12
21. Using a tape measure, adjust the right flip stop to 12” from the blade. Adjust the fence ruler (225) so that it
indicates 12” in the flip stop indicator lens. This adjustment ensures exact measurements when cutting using
the flip stop with the miter gauge set to the 0 degree mark. When the miter gauge is adjusted to an angle
other than 0 degrees, the fence ruler will need to be readjusted before using the flip stop indicator lens.
22. To properly position the ruler on the crosscut fence extension, slide the left flip stop to the left-most position
on the crosscut extension section. Next, slide the extension ruler left until it stops. Using a tape measure,
extend the crosscut fence extension out until the distance between the blade and the left flip stop is 50”.
Check the indicator reading on the extension fence. If the indicator does not read 50”, adjust the position of
the flip stop until the indicator reads 50”, then lock the flip stop in place by tightening the lock knob. This
adjustment ensures exact measurements when cutting using the flip stop on the crosscut fence extension
with the miter gauge set to the 0 degree mark. When the miter gauge is adjusted to an angle other than 0
degrees, the extension ruler will need to be readjusted before using the flip stop indicator lens.
Note: The rulers on the fence and the fence extension are double-sided. Flip
them over for metric measurements.