SawStop Sliding Crosscut Table User Manual

Page 14

Text mode
Original mode

SawStop TSA-SA48 Sliding Crosscut Table | 10

14. Slide the miter gauge bar (249) into the T-slot on the sliding table top nearest the blade, as shown in

Fig. 11.

For full cutting capacity, the miter gauge bar should be positioned flush with the front edge of the sliding
table. Use a 5mm wrench to turn the

reverse-thread fasteners (248) at the front and rear of the miter gauge

bar COUNTERCLOCKWISE to lock the miter gauge bar in place.

Fig. 11

15. Remove the T-bolt (229) from the Crosscut Fence Lock Knob and insert the threaded shaft of the T-bolt up

through the slot on the fence as shown in

Fig. 12. Pivot the fence clockwise and slide the T-bolt into the

T-slot in the left side of the sliding table top. Place the plastic washer (228) on the T-bolt threaded shaft and
then screw on the crosscut fence lock knob. Do not tighten the lock knob at this time.

Fig. 12