SawStop Sliding Crosscut Table - Manual (Page 13)

SawStop TSA-SA48 Sliding Crosscut Table | 9
12. For PCS and CNS saws ONLY: Attach the switch box assembly to the mounting bracket on the underside of
the sliding table using three M6x1.0x16 cap screws, six M6 washers, three M6 lock washers and three M6
nuts, as shown in
Fig. 9.
Fig. 9
(PCS Model Shown)
13. Place the two M8 T-bolts (109) through the holes in the side of the extension table. Loosely install the flat
washers (108) and lock nuts (110) on the T-bolts. Slide the heads of the T-bolts (109) into the T-slot on the
outside edge of the sliding table, and then tighten the nuts (110) to secure the extension table in place. For
most operations, position the extension table so that it is flush with the front edge of the sliding table top, as
shown in
Fig.10.
Fig. 10