RMS Technologies IMC17 INTEGRATED MOTOR CONTROLLER/DRIVER User Manual
Page 21
Connecting to the old non-RoHS RS232 card
SP17C pin# SP17C color
RS232 card pin#
4
Black/white
A (RS485A)
3
Brown
B (RS485B)
6
Green
- (GND)
1
Red
+ (PWR)
Table 4
Figure 2
The RS232 card requires power (7-40VDC). Power is then sent to the motor via the Red 4-Pin connector.
Figure 5: Connection using RS232
5.
The RS232 converter card connects to the IMC17 using the DB-9 cable that is
provided to you. The red 4-Pin connector is placed onto the converter card.
6.
Your power supply will be connected to the RS232 card where the green
header is located. + is for +12-40VDC, - is for the Power Supply
Ground.
7. Connect the RS232 card to your PC with a male to female DB-9 cable.
8. Turn your power supply on and follow instructions for using HyperTerminal.
How to connect with old cable:
If you have a cable with a Red 4-Pin connector, simply cut off this connector,
strip the wires and reconnect to a 3-Pin connector in the following manner:
RMS Technologies
Page 21
4/3/2009
IMC17/IMCE17 User Manual
Rev 1.06