Rivera Primo SU Rebuild User Manual

Page 7

Set the Main Jet so that it is

flush with the seat bevel.

Adjust the Main Jet Adjusting

Screw to set the Main Jet.

Bi-metallic Lever & Main Jet

installed.

Install Viton Cup on Tickler

Stem.

Note the relief for the top of the

Main Jet.

Note that slot in Lever and end

of Adjusting screw are aligned.

Install Float Bowl Cover with

(4) screws & lock washers.

Float Bowl Cover in place for

installation.

Place oring into Float Bowl

Cover.

Sqeeze end of small Tickler

Spring so it will stay on Stem.

Use the Screw & Spring to

hold down Bi-metallic Lever.

Tickler Pump parts.

NOTE: When installing the Bi-metallic hold down screw, just thread it in until it stops. Care must

be taken to not overtighten as the screw might break. Install Viton Cup on Tickler Stem with open

end of Cup pointed away from stem. Using a pliers, squeeze the end of the small tickler spring

so that it will”pop” on the stem and stay. Install the fiber gasket onto the Tickler Nut and then slide

the Stem, Cup & Spring into the Nut.