A&D TM-2430-13 - Manual (Page 6)

5
1-4 Software Package Components
Items included in your complete software package are:
♦
ABPM 3.5-inch program disk
♦
Ambulatory Blood Pressure Monitor Data Analysis Software Instruction Manual
♦
For TM-2420/TM-2421
AX-KO600 (9 pin D-SUB, socket type), Communication cable for TM-2420/TM-2421
♦
For TM-2430 series/UA-767PC
AX-KO1502 (9 pin D-SUB, socket type), Communication cable for TM-2430 series
1-5 System Requirements
♦
Computer A 486DX or higher microprocessor
♦
RAM Memory Minimum 16 MB
♦
Operating System Windows™ 95, 98, Me, 2000, NT 4.0
♦
Graphic Adapter SVGA video card
(minimum of 256 colors, 800X600 pixels or higher
recommended)
♦
Disk Type 3.5-inch floppy disk drive
♦
Hard Disk At least 2.5 MB
♦
Serial Ports Minimum one (9 pin D-SUB or 25 pin D-SUB)
(A cable separately available is required for the 25 pin
D-SUB serial port)
♦
Printer Type Printers supported by MS Windows™ operating system
1-6 Installing the Software
The software must be run from a hard disk drive only. It may not be run from a floppy disk. To
install the software on your hard disk drive, complete the following instructions:
Step 1 Insert the program disk in drive A:.
Step 2 Click the Start button on the Windows taskbar and select Run.
Step 3 Type “a:setup”
Step 4 Click OK.
Step 5 Follow the instructions on the screen.
Note The serial number is required when installing the software. The serial number is
printed on the label of the program disk.
1-7 Safety
Do not attach the monitor to a patient when the monitor, or the monitor and the processor, are being
connected to a computer.