Rugged Ridge 3,000 Pound Heavy Duty Winch, ATV/UTV - Manual (Page 11)

11
Step 3 - Mount the Handlebar Switch
TO PREVENT SERIOUS INJURY OR DEATH FROM
ELECTICAL FIRE:
• Do NOT route electrical cables across sharp edges.
• Do NOT route electrical cables through or near moving parts.
• Do NOT route electrical cables through or near any high heat parts.
• Avoid pinch and wear/abrasion points when installing all electrical
cables.
• It is recommended that the switch be installed on the left handlebar. A
piece of electrical tape around the handlebar will help prevent rotation
of mount on the handle bar. (See Figures 3 & 4)
• Do NOT tighten over any hoses or cables.
• Once the handle bar switch is mounted, route the cord and connector
to the remote socket mount location.
TO AVOID INJURY AND PROPERTY DAMAGE:
• Use caution when moving or repositioning any ATV/UTV controls so as
to not com promise the safe operation of the ATV. Select a mounting
position that will provide clearance for all ATV/UTV controls.
• Before securing the switch cable with tie wraps, make sure that the
handlebars have full range of motion.
Figure 3: Handlebar mount
assembly. Exact positioning may
vary depending on ATV make and
model. Figure 4: Mini-rocker switch