Martin Universal Design U-DS92STB Ashley Table with Stool - Manual (Page 7)

Step 12: Board Brace to Base
Fastener Parts Needed for this Step : 20 = 2 ea.
Attach Board Brace (Part ) to the base using the
6x45mm bolt (Part ).
Secure using the Allen Wrench (Part )
7
7
20
20
20
20
23
Step 13: Adjustments
HEIGHT ADJUSTMENT:
To adjust the height of your table - loosen the knobs on the collars found on the base of the
table and lift the table top to desired height.
TILT ADJUSTMENT:
To adjust the tilt of your table top, grab the back edge of the table top and lift the top with [2]
hands to the maximum tilt and then back down to your desired position.
NOTE: You must lift the table top all the way up before lowering it to the desired tilt level.
NOTE: If the top does not seem to move smoothly - this means you are NOT holding the top
balanced with both hands. Make sure your hands are positioned evenly. This will make the
adjustments easier.
LEVELING FLOOR GUIDES:
If your floor is uneven, you can adjust the floor guides by loosening the floor guides to make
up for the uneven floor.
In order to lower the table top, lift it all the way up to its maximum height which allows the tilt
mechanisms to release from their locked position. To avoid damaging the table top,
DO NOT attempt to lower the table top by forcefully pushing down on the top when its in a
locked position.
20
7
10/2011 - RPI
4444 Lawton Street, Detroit, MI 48208 USA / Tel: 1-313-895-0700 / Fax: 1-313-895-0709
E-mail: [email protected] / www.MartinUniversalDesign.com