Martin Universal Design U-DS92STB Ashley Table with Stool User Manual
Page 3

Step 1: Base Assembly & Cross Support
Step 2: Lower Base End
Step 3: Floor Guides
Fastener Parts Needed for this Step : 20 = 4 ea.
Start with taking the [2] Lower Base Ends (Part ),
spreading them apart, and inserting the Cross Support
(Part ) between them as seen in the Image.
Attach the three pieces together with [4] 6x45 mm bolts
(Part ).
Tighten with Allen Wrench (Part )
Fastener Parts Needed for this Step : 17 = 2 ea.
19 = 2 ea.
Now continue by taking the lower base end units (Part
and attach the base floor support, the long circular tube, to
the base ends.
Do this by putting a 6x55 bolt (Part ) through one of the
lower base ends. Then place the spacer (Part ) so it
rests against the lower base end making sure the C shape
faces the base end and the flat part faces you.
Now screw into Base Floor Support (Part ) using Allen
Wrench (Part ). Repeat for the opposite side!
Now attach the [4] Floor Guides (Part ) into the base by
screwing the guides into the specified holes on the bottom of
the base units.
4
5
5
20
23
20
20
4
4
23
4
19
17
6
6
6
4
23
19
19
19
17
17
17
16
16
16
16
4
10/2011 - RPI
3