Minka Group F707-FLP - Manual (Page 21)

TROUBLESHOOTING
12
SYMPTOM
Fan will not start
SOLUTION
1.Check to make sure the wall switch is turned on.
2.Check circuit fuses or breakers.
3.Cantion! Make sure the power is turned off
before performing the following steps.
4.Remove canopy and check wire connections.
5.Check wall control transmitter connections
(ifapplicable).
6.Note: Fan must be installed from a maximum
distance of 40 feet from the transmitting unit
for proper signal transmission between the
transmitting unit and the fan's receiving unit.
SYMPTOM
Fan Wobble
SOLUTION
1 .NOTE: All blade sets are grouped by wei-
ght. Because wood and plastic blades
vary in density, the fan may wobble even
though blades are matched.
2.Make sure all blade attachment screws
are tight.
3.Make sure outlet box is secured to buil-
ding structure, if necessary use the wood
screws provided to further secure outlet
box to joist.
4.Make sure hanger bracket is secure to the
outlet box, screws are tight.
5.Use the balancing kit provided if the
wobble is excessive (follow instructions
included with balancing kit).
SYMPTOM
Fan will not start
SOLUTION
1. Allow a 24-hour "break in"
period.
Most noises associated
with a new fan will go
away during this time.
2.Make sure all blade
attachment screws are tight.
3.Make sure outlet box is
secured to building structure, if
necessary use the wood
screws provided to further
secure outlet box to joist.
4.Make sure hanger bracket
is secure to the outlet box,
screws are tight.
SYMPTOM
Lights shut off and will not
come back on.
SOLUTION
1. This unit is equipped with a wa-
ttage limiting device Lamping in
excess of 190 watts will disable
your ceiling fans light kit. To re-
set your light kit you must turn
the power off and relamp Keep-
ing the wattage under 190 watts.
Restore power to your ceiling fan
and continue normal operation.
SYMPTOM
Fan/Light turn on and off unexpectedly
SOLUTION
2.This is caused by interference. Ple-
ase see “Frequency interference”
for steps to change the frequency.