Minka Group F707-FLP - Manual (Page 16)

THE FOLLOWING OPERATION MUST BE ACCOMPLISHED BEFORE
INSTALLING THE LIGHT KIT.
Step 1. Attach the fan blades to the blade holders using the screws &
fiber washers provided. (Fig 18).
Step 2. Align holes from blade holder to motor and secure with 2
screws provided. (Fig 19).
All blade sets are grouped by weight. Because natural woods vary in
density, the fan may wobble even though the blades are weight
matched. The following procedure should correct most fan wobble.
Check after each step.
ATTACHING THE BLADES
8
BLADE HOLDER
FIBER WASHER
BLADE
Fig.19
SCREW
BLADE HOLDER
Fig.18
3/16"X1/2" SCREW