MIPRO ACT-818 Wideband Single-Channel Digital Receiver - Manual (Page 11)

16 17
Encryption ( ): to Add or Remove Encryption
Encryption Instructions:
1. Press the rotary controller to activate and move the cursor to the icon. When the
icon starts to flash and the word “NO” appears, the encryption function is ready to
be set.
2. Press and hold the rotary controller for approximately 3 seconds until the word
changes from “NO” to “YES”.
3. Press rotary controller once to confirm and save the selected “YES” for encryption.
The transmitter now needs to be synced to the receiver using the ACT function to
apply the encryption.
NOTE:
! Encryption is factory set by default to “NO” in the receiver (encryption OFF).
! The transmitter can only display encryption status and cannot activate/de-
activate encryption.
! The 128-bit encryption key is randomly generated; hence, a new, secure,
encryption key is also downloaded to a transmitter each time an ACT function is
synced successfully.
! This means the last encrypted transmitter will work only with the encrypting
receiver. It also means that previously encrypted transmitters will not work with
the encrypting receiver even though they are on the same frequency as there
will be no audio output. This method also ensures that another similar receiver
cannot listen in to the encrypted transmitter.
Press & hold to encrypt or decrypt
Wideband Digital Receivers Wideband Digital Receivers
(Encrypted) (Not Encrypted)
Hold  for
2~3 Seconds
Aim TX to
ACT Button
Encrypted
Encryption
No→YES
TX
ENCRYP→No
Press ACT
Button
Not Encrypted
Encryption Setup Flow Chart
Decryption Instructions:
1. Press the rotary controller to activate and move the cursor to the icon. When the
icon starts to flash and the word “YES” appears, the Encryption function is ready to
be set.
2. Press and hold the rotary controller for approximately 3 seconds until the word
changes from “YES” to “NO”.
3. Press the rotary controller once to confirm and save the selected “NO” to turn off
the Encryption. Transmitter now needs to be re-synced using ACT to turn transmitter
encryption OFF.
Encryption
YES→No
Aim TX to
ACT Button
Press ACT
Button
TX
ENCRYP→Yes
Encryption icon starts flashing
MHz
L
ACT
RF AF SQ
ANT
ADD EQ CH GRP BA BA
MHz
L
ACT
RF AF SQ
ANT
ADD EQ CH GRP BA BA
MHz
L
ACT
RF AF SQ
ANT
ADD EQ CH GRP BA BA
" "
" "
indicates receiver is encrypted
indicates receiver is not encrypted