Fagor 3CF-950SXBUT - Manual (Page 28)

28
mum size, checking that it is suffi ciently
stable even in quite strong draughts.
SETTING OVEN BURNER MINIMUM
LEVELS
If the cooker is to work on bottled gas (bu-
tane/propane), the thermostat by-pass must
be screwed right down.
If the cooker is to work on natural gas, pro-
ceed as follows:
- Remove the oven bottom (push towards
the back and raise);
- ignite the oven burner, turning the knob
pointer to the maximum setting;
- shut the oven door;
- access the thermostat by-pass (see fi g.
10);
- back off the thermostat by-pass by about 3
turns;
- after 5 or 6 minutes, turn the knob pointer
to the minimum setting;
- slowly re-tighten the by-pass, watching the
fl ame decrease in size through the window
in the closed oven door until the tongue of
the fl ame is about 4 mm long. Never keep
the fl ame too low. It must be stable even
when the oven door is opened or closed
quickly;
- turn off the burner and replace the oven
bottom.
CONNECTING TO THE ELECTRICAL
MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the
nameplate;
- the earth connection is in good working
order.
If the socket is not easily accessible, the in-
stallation engineer must provide a switch with
a contact breaking gap of 3 mm or more.
If the appliance power lead is not fi tted with
a plug, use an approved standard type, re-
membering that:
- the green-yellow wire must be used for the
earth connection;
- the blue wire is the neutral;
- the brown wire is live;
- the lead must never touch hot surfaces over
about 75 degrees C;
- replacement leads must be of type HO5RR-
F or H05V2V2-F of suitable size (see dia-
grams in fi g. 2).
- if the appliance is supplied without lead,
using type HO5RR-F or H05V2V2-F cable
of suitable size (see diagrams in fi g. 2).
IMPORTANT: the manufacturer declines all
liability for damage due to failure to comply
with the regulations and standards in force.
Check that the appliance is correctly con-
nected to the earth (see diagrams in fi g. 2
at the back of the manual).
FOR COOKERS WITH ELECTRIC IGNI-
TION
The correct gaps between the electrode
and the burner are shown in figures
7a,7b,8a,8b,
If no spark is generated, do not keep on trying
as this might damage the generator.
Possible causes of malfunctions:
- spark plug damp, dirty or broken;
- electrode-burner gap not correct;
- spark plug wire broken or without sheath-
ing;
- spark discharging to earth (to other parts
of the cooker);
- generator or microswitch damaged;
- air has built up in the pipes (particularly if
the cooker has been out of use for a long
time);
- air-gas mixture incorrect (poor fuel set-
ting).
THE SAFETY DEVICE
The correct gap between the end of the ther-
mocouple sensor and the burner is shown in
fi gures 7a,7b,8a,8b.
To check that the valve is working properly,
proceed as follows:
- ignite the burner and leave it to work for
about 3 minutes;
- turn off the burner by returning the knob to
off position ( );
Installation GB