Fagor 3CF-950SXBUT - Manual (Page 27)

27
Installation GB
that the gas pressure is as indicated on the
nameplate.
IMPORTANT:
- Use only standard rubber hoses. For LPG,
use a hose which complies with the national
regulations in force.
- Avoid sharp bends in the pipe and keep it
well away from hot surfaces.
References to the regulations covering the
gas connection to the appliance: ISO 7-1.
ADAPTING TO DIFFERENT TYPES OF
GAS
If the cooker is not already preset to oper-
ate with the type of gas available, it must be
converted. Proceed as follows:
- Replace the injectors (see table on page
25);
- regulate the primary air fl ow;
- regulate the minimum settings.
N.B.: every time you change the type of gas,
indicate the new type of gas on the serial
number label.
REPLACING THE HOB BURNER INJEC-
TORS (fi g. 6)
- Remove the grid, the burner caps (A), and
the burners (B);
- Unscrew and remove the injector in the
bottom of each injector holder (C);
- replace the injector in accordance with the
table in page 25, tighten and screw right
down;
- check that the system is gas-tight;
- replace the burners, the burner caps and
the grid.
With triple fl ame burners (fi g. 6b):
- carry out the operations already described
and also
- unscrew the two screws which secure the
guard plate (D) and replace the side injector
as indicated in the table on page 25, screw
in and tighten fully.
IMPORTANT:
- Never over-tighten the injectors;
- after replacing, check that all the injectors
are airtight.
REPLACING THE OVEN BURNER INJEC-
TOR (fi g. 7a)
- Loose the screw securing the oven bot-
tom;
- remove the oven bottom (push back and
raise);
- remove the oven burner, after taking out its
fi xing screw;
- replace the injector, using a 7 mm socket
wrench.
REPLACING THE GRILL BURNER INJEC-
TOR (fi g. 7b)
- Remove the burner after taking out the two
screws which secure it;
- replace the injector using a 7 mm socket
wrench.
IMPORTANT:
- Never over-tighten the injectors;
- after replacing, check that all the injectors
are airtight.
SETTING HOB BURNER MINIMUM LEV-
ELS
If the cooker is to work on bottled gas (bu-
tane/propane), the tap by-pass must be
screwed right down.
The cooker may be equipped with type A
taps, with by-pass inside (accessed by insert-
ing a small screwdriver into the rod) or type B
taps, with by-pass on the outside on the right
(accessed directly). See fi gure 9.
If the cooker is to work on natural gas, pro-
ceed as follows for both types of tap:
- Ignite the burner at maximum fl ame;
- pull off the knob, without using a lever
against the control panel, which might be
damaged;
- access the by-pass with a small screwdriver
and back off by about 3 turns (turning the
screwdriver anti-clockwise);
- turn the tap rod anti-clockwise again until
it stops: the burner will be at maximum
fl ame;
- screw the by-pass slowly back in, without
pushing the screw-driver, until the fl ame
has apparently shrunk to 1/4 of the maxi-