DiGiCo SD Series Broadcast - Manual (Page 17)

DiGiCo SD Series Broadcast Options
1-17
1.2.10 Headphone Panel ...............................................................
The console headphone output is configured using the Headphones Panel, on the Master Screen in the Setup Menu > Headphones.
There are 5 choices for the source of the headphones; Solo 1, Solo 2, Speakers, Auxes or Groups.
If Solo 1 or Solo 2 is pressed, the headphone output will carry the audio on the selected solo buss.
If Speakers is selected, the headphones will follow the monitoring source as set by the source selection in the monitoring setup.
Note : When Speakers is selected, the level of the headphones is set by the headphone controls, not the speaker controls. Speaker Mute
and Speaker Dim will not affect the headphone level.
The Groups and Auxes buttons allow you to set the headphones to follow any single buss. For Example, if you always want to listen to the
Master buss on the headphones, press the groups button, then select the Master Group buss from the list of group busses.
Note : When a new session is started, there is no default headphone source, and the headphone output will not pass audio.