DiGiCo SD10 User Manual
User manual - getting started
Table of contents
Document Outline
- Contents
- 1.1 Introduction .......
- 1.2 Manual Overview .......
- 1.3 Before You Start .......
- 1.3.1 Worksurface Layout .......
- 1.3.2 Screen Assignment .......
- 1.3.3 Layers and Banks .......
- 1.3.4 Using the Control Surface .......
- 1.3.5 The Assigned Channel .......
- 1.3.6 The Master Fader .......
- 1.3.7 Other Centre Section Controls .......
- 1.3.8 Channel Types .......
- 1.4 Hardware Configuration .......
- 1.4.1 Connections .......
- 1.4.2 Audio I/O Panel .......
- 1.4.3 Opto V220 (DiGiRacks) and Opto V221 (SD Racks) .......
- 1.4.4 Single SD Console System .......
- 1.4.5 Rack Connections .......
- 1.4.6 Rack Sharing .......
- 1.5 Configuring a Session .......
- 1.5.1 Session Structure .......
- 1.5.2 Assigning Faders to the Worksurface .......
- 1.6 Saving and Loading Sessions .......
- 1.7 Audio Sync .......
- 1.8 Routing Basics .......
- 1.8.1 Selecting Inputs & Outputs .......
- 1.8.2 Ripple Channels .......
- 1.8.3 Channel Names .......
- 1.9 Channel Processing .......
- 1.9.1 EQ .......
- 1.9.2 Dynamics .......
- 1.9.3 Auxiliaries .......
- 1.10 The Matrix .......
- 1.11 Control Groups .......
- 1.12 Solo Setup .......