Beijer Electronics iX Panel TA100 EN - Manual (Page 40)

Software
12 Software
This chapter describes how to maintain and update the software in the iX Panels.
The chapter includes a general description of the operator panel software and
instructions about how to upgrade the software and load projects and system
programs.
12.1 General Information about
Software
The software required to run and maintain the operator panels is found on the
software USB stick. It is also available through your local distributor.
The software is tested by the manufacturer’s own testing department before
market introduction is approved. The test procedure is closely integrated with the
development process. The test group works in close concert with the developers
and is ISEB Certified for Software Testing.
12.1.1 Software Products
The following software products are used:
• iX Developer
iX Developer is used for creating application projects for iX Panels and their
accessories.
• Remote Access Viewer
Remote Access Viewer is a program for remote access and control of the iX Panels.
It is possible to access, reflect and control the iX Panels from a PC using the VNC
client program Remote Access Viewer (freeware) together with the built-in VNC
server (Remote Access function) in the iX Panels.
• System Program
The iX Panel TA100 is delivered with an image (operating system) pre-stored in
the operator panel memory.
Beijer Electronics, MAEN013A 40