Beijer Electronics iX Panel TA100 EN - Manual (Page 19)

Hardware Replacement
7 Hardware Replacement
This section contains instructions on how to replace operator panel hardware.
Only components included in the latest bill of material and spare parts list are
allowed. See
Available Spare Parts for iX Panel TA100 .
7.1 Mode Switches
The iX Panel TA100 has four mode switches (DIP switches) located on the rear
side of the operator panel.
1
24V DC
CF CARD
COM 1 RS422 RS485 COM 2 RS232 10/100
EXP
ANSION
BUSY
MODE 1 2 3 4 ON DIP
MODE
1 2 3 4
ON DIP
Warning:
The modes below are to be used with caution.
The mode switches have the following functions: 1=ON, 0=OFF
Each letter in “MODE” has a corresponding mode switch.
MODE Description
0000 “Run mode” - boots CE, normal operation.
0010 Not used.
0100 Not used.
1000 Service Menu mode, the service menu for the system program is
shown. Allows the user to set IP configuration, erase the project,
calibrate the touch screen etc. See section
Service Menu for details.
1100 Not used (run mode).
1110 Self test.
xxx1 Not used.
To change mode switches, follow the steps below:
1. Disconnect power from the operator panel.
2. Set the mode switches using a ballpoint pen.
3. Reconnect power to the operator panel.
Beijer Electronics, MAEN013A 19