Beijer Electronics iX Panel TA100 EN - Manual (Page 25)

Hardware Replacement
7.6 Replacing the Backlight
Note:
All lamps in the display must be replaced at the same time.
The following is needed:
• A new backlight, see Available Spare Parts for iX Panel TA100
• A torx T10 screwdriver
Note:
Make sure to use adequate ESD protection.
Follow the steps below to replace the battery of the iX Panel TA100:
1. First, follow the steps 1–5 in section
Replacing the Rear Cover .
2. Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
3. Remove the backlight from the display.
backlight snap lock
backlight
connectors
4. Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
5. Re-assemble the complete operator panel.
Beijer Electronics, MAEN013A 25