AZEK Trim & Moulding EN - Manual (Page 2)

Page 2
STORAGE &
HANDLING
• Store AZEK Trim and Moulding products on a flat and level surface.
• Since AZEK Trim and Moulding products are more flexible than wood, they may conform
to uneven surfaces. Ensure that storage areas, as well as all framing and substructures,
are flat and level to minimize uneven surfaces.
• AZEK Trim and Moulding products have a density comparable to pine and should be
handled in a fashion as pine would be handled to avoid damage.
• Units of AZEK Trim and Moulding products are shipped from the manufacturer in a
protective covering. If covering has been removed, take care to keep product free of
dirt and debris at jobsite. If product gets dirty, clean after installation.
CUTTING
• AZEK Trim and Moulding products can be cut using the same tools used
to cut lumber.
• Carbide tipped blades designed to cut wood work well. Avoid using fine
tooth metal cutting blades.
• Rough edges from cutting may be caused by excessive friction, poor
board support, or worn or improper tooling.
DRILLING
• AZEK Trim and Moulding products can be drilled using the same tools
used to drill lumber.
• Drilling AZEK Trim and Moulding products is similar to drilling a hardwood.
Care should be taken to avoid frictional heat build-up.
• Periodic removal of AZEK shavings from the drill hole may be necessary.
• AZEK Trim and Moulding products can be routed using standard router
bits and the same tools used to rout lumber.
• Carbide tipped router bits are recommended.
• Routing AZEK Trim and Moulding products provides a crisp, clean edge.
ROUTING
Installation Guidelines for AZEK Trim and AZEK Moulding