Vaddio CeilingVIEW HD-18 DocCAM - Manual (Page 7)

CeilingVIEW HD-18 DocCAM Series
CeilingVIEW HD-18 DocCAM Manual - Document Number 342-0195 Rev. B 7 of 24
Camera Switch Settings (rotary and dip switches):
The CeilingVIEW HD-18 DocCAM has a 16-position rotary switch to select HD camera resolutions or three (3) of
the most used RGBHV resolutions today. The camera also has an 8-position dip switch for assigning certain
camera functions. The following Label appears on the back of the camera enclosure back box:
Dip Switch Settings Table:
SW Function Default Description/Notes
1 IR ON/OFF ON Allows IR remotes to control the camera,
Turn IR off if using RS-232 for camera control
2 Baud Rate 9600 bps 9600 bps works well with Vaddio equipment, especially over distance
3 Alternate IR
Remote OFF Turn ON to use zoom in/out controls with Polycom®, LifeSize® or
Cisco®/TANDBERG IR remote controls. The tilt down command on
these remotes will activate the momentary laser pointer for document
positioning.
4 Laser Pointer ON Allows the Laser Pointer to be controlled by IR remote or RS-232
when ON, Turn OFF if the Laser Pointer is not used
5 Test Bars OFF Convenience, Non-standard Color Bars Only
6 Not Used OFF Leave OFF
7 Not Used OFF Leave OFF
8 Not Used OFF Leave OFF
Video Select - Rotary Switch:
Select the HD video resolution best suited to the application where the camera is
installed. The HSDS™ (differential) video is routed to the Quick-Connect SR or
the Quick-Connect DVI/HDMI Interfaces over a Cat-5e cable. The DE-15 (15pin-
HD) connector will also output the analog YPbPr signal on the back of the back
box enclosure.
The three (3) most popular RGBHV resolutions are also included, selecting
positions 9, E or F will override the YPbPr output and that output will no longer
function. RGBHV in 1024x768@60Hz, 1280x800@60Hz and 1680x1050@60Hz
will be delivered out of the DE-15 on the back of the camera module only. The
Quick-Connect SR Interfaces will no longer output YPbPr or DVI/HDMI video.
When the dip and rotary switches are set for the application, put the cover caps back on and proceed with the
installation. These switches are accessible from the front of the camera after installation and can be easily
changed.
IR
ON
1
38400
bps
2 3 4 5
DIP SWITCH SETTINGS
9600
bps
1080p/60 B 3
7
6
5
4
1080p/50
1080i/50
720p/50
F
E
D
C
VIDEO SELECT
2
0
1080p/59.94
1 1080i/59.94
720p/59.94
A
9
8
1280 x 800/60 RGBHV
1680 x 1050/60 RGBHV
1024 x 768/60 RGBHV
ON
6 7
8
OFF
ON
8
7
OFF
IR
OFF
ALTERNATE
IR REMOTE
OFF
LASER
ON
OFF
TEST
BARS
OFF
6
OFF
1080p/30
1080p/25